Mission Code Manager Rule (SP2 and later).Rules that MUST be added to the Session for this Driver Command to operate SetMissionCode (TANE SP4 and Later) - removes a mission code from those already set for the train.RemoveMissionCode (TANE SP4 and later) - sets a mission code for the train.Notes: The mission code must be created by the Mission Code Manager Rule (SP2 and Later) using paths created with Interlocking Towers Minimum Trainz Build: 4.5 (TANE SP2) (earlier builds are available)Ĭommand Settings: - select a mission code from the Session list.The mission code must be set by the Mission Code Manager Rule (SP2 and Later) Interlocking Tower and Mission Code Commands Commands that manage navigation paths set by Interlocking TowersĪdds a mission code (a sequence of IT or EIT paths) to any mission codes already loaded for the train. 1.7 SetMissionCode (TANE SP4 and Later).1.6 RemoveMissionCode (TANE SP4 and later).1.5 IT SetPathAndWaitNotRed (TANE SP4 and later).1.4 IT SetPathAndWaitActive (TANE SP4 and later).1.2 IT CancelEnhancedPath (TANE SP4 and later).1.1 AddMissionCode (TANE SP4 and later).1 Interlocking Tower and Mission Code Commands.SP2 and later and SP4 and later means TANE SP2/SP4 and later versions including TRS19 and Trainz Plus.Legacy Command has been replaced by another command (new command will be identified).Obsolete Command is no longer required (explanation given).Older builds may be available on the DLS. This can change to a higher build if the command is updated. Minimum Trainz Build is the minimum version of Trainz required for the listed version of this driver command to work.Base Command and Built-in Command are installed with Trainz.DLS Command must be downloaded and installed from the DLS.This number will change if the command is updated. is for the driver command version at the time of writing.

Those commands that are identified as a DLS Command must be downloaded and installed from the Trainz DLS first. The driver commands listed in this page are all accessible in the Surveyor Session Editor using the Driver Setup Rule. Only driver commands supplied with Trainz or on the DLS are covered in this document. As new driver commands appear and are tested they will be added to this list. The information in this Wiki Page applies to TANE, TRS19 and Trainz Plus.

Vagoni dlya trainz 2012